OscilloscopeBlock.py

# OscilloscopeBlock.py
#
# This example performs a block mode measurement and writes the data to OscilloscopeBlock.csv.
#
# Find more information on http://www.tiepie.com/LibTiePie .

import time
import sys
import csv
import libtiepie
from printinfo import *

# Print library info:
print_library_info()

# Enable network search:
libtiepie.network.auto_detect_enabled = True

# Search for devices:
libtiepie.device_list.update()

# Try to open an oscilloscope with block measurement support:
scp = None
for item in libtiepie.device_list:
    if item.can_open(libtiepie.DEVICETYPE_OSCILLOSCOPE):
        scp = item.open_oscilloscope()
        if scp.measure_modes & libtiepie.MM_BLOCK:
            break
        else:
            scp = None

if scp:
    try:
        # Set measure mode:
        scp.measure_mode = libtiepie.MM_BLOCK

        # Set sample frequency:
        scp.sample_rate = 1e6  # 1 MHz

        # Set record length:
        scp.record_length = 10000  # 10000 samples

        # Set pre sample ratio:
        scp.pre_sample_ratio = 0  # 0 %

        # For all channels:
        for ch in scp.channels:
            # Enable channel to measure it:
            ch.enabled = True

            # Set range:
            ch.range = 8  # 8 V

            # Set coupling:
            ch.coupling = libtiepie.CK_DCV  # DC Volt

        # Set trigger timeout:
        scp.trigger.timeout = 100e-3  # 100 ms

        # Disable all channel trigger sources:
        for ch in scp.channels:
            ch.trigger.enabled = False

        # Setup channel trigger:
        ch = scp.channels[0]  # Ch 1

        # Enable trigger source:
        ch.trigger.enabled = True

        # Kind:
        ch.trigger.kind = libtiepie.TK_RISINGEDGE  # Rising edge

        # Level:
        ch.trigger.levels[0] = 0.5  # 50 %

        # Hysteresis:
        ch.trigger.hystereses[0] = 0.05  # 5 %

        # Print oscilloscope info:
        print_device_info(scp)

        # Start measurement:
        scp.start()

        # Wait for measurement to complete:
        while not scp.is_data_ready:
            time.sleep(0.01)  # 10 ms delay, to save CPU time

        # Get data:
        data = scp.get_data()

        # Output CSV data:
        with open('OscilloscopeBlock.csv', 'w', newline='') as csvfile:
            writer = csv.writer(csvfile)
            writer.writerow(['Sample'] + [f'Ch{i + 1}' for i in range(len(data))])  # Header
            for i in range(len(data[0])):
                writer.writerow([i] + [(data[j][i] if i < len(data[j]) else '') for j in range(len(data))])

            print()
            print(f'Data written to: {csvfile.name}')

    except Exception as e:
        print(f'Exception: {e}')
        sys.exit(1)

    # Close oscilloscope:
    del scp

else:
    print('No oscilloscope available with block measurement support!')
    sys.exit(1)

sys.exit(0)