A lot of the standard functionality of the Multi Channel oscilloscope software can be controlled by hotkeys. Below is a list.
Per instrument | |
---|---|
F3 / F4 | Decrease / increase sample frequency |
F11 / F12 | Decrease / increase record length |
Ctrl + F11 / F12 | Decrease / increase Time per division |
S | Start / Stop |
O | Start Oneshot / Stop |
0 | Trigger time out = 0 |
1 | Trigger time out = 1 s |
W | Toggle trigger time out infinite and previous value |
Shift + ← / → | Change pre-/post samples ratio |
space | Directly force a trigger |
Q | Perform a quick Auto Setup |
Ctrl + Q | Perform a quick Auto Setup and keep following the signal |
Per channel | |
---|---|
F5 / F6 | Decrease / increase range |
R | Autoranging on / off |
F7 / F8 | Decrease / increase trigger level |
[ / ] | Decrease / increase trigger hysteresis |
A | AC-coupling |
D | DC-coupling |
Per graph | |
---|---|
L | Interpolation |
U | Zoom out |
Ctrl + Del | Clear graph |
Shift + Del | Delete graph |
← / → | Move scrollbar slider |
Ctrl + ← / → | Move left edge of the scrollbar slider |
↑ / ↓ | Move right edge of the scrollbar slider |
T | Full record view |
X | XY mode |
Y | Yt mode |
Common | |
---|---|
Ctrl + O | Open settings and measured data |
Shift + Ctrl + O | Open a Quick Setup |
Ctrl + S | Save settings and measured data |
Ctrl + P | Print measured data |
F1 | Context sensitive help |
Shift + [ 1 ... 0 ] | Select graph 1 through 10 |
Ctrl + [ 1 ... 0 ] | Select instrument 1 through 10 |
Alt + S | Search instruments |
The channel hotkeys mentioned by default apply to channel 1. However, if the hotkeys are used with the keys mentioned in the table below, the hotkey applies to the indicated channel.
Key(s) | Channel |
---|---|
- | Ch. 1 |
Ctrl | Ch. 2 |
Shift | Ch. 3 |
Ctrl + Shift | Ch. 4 |
Alt | Ch. 5 |
Alt + Ctrl | Ch. 6 |
Alt + Shift | Ch. 7 |
Alt + Ctrl + Shift | Ch. 8 |
Hotkeys for the Arbitrary waveform generator window
The Arbitrary Waveform Generator can be controlled by hotkeys. Below is a list.
Common | |
---|---|
F2 | Toggle generator output on / off |
Ctrl + F2 | Toggle generator output invert |
F3 .. F9 | Select signal type sine .. arbitrary |
F | Set frequency through popup window |
A | Set amplitude through popup window |
O | Set offset through popup window |
S | Set symmetry through popup window |
P | Set phase through popup window |
B | Set burst count through popup window |
D | Set sweep duration through popup window |
W | Set pulse width through popup window |
space | Start / stop |
Ctrl + O | Open settings and/or arbitrary data |
Ctrl + S | Save settings and/or arbitrary data |