Current clamp TP-CC600

The Current clamp TP-CC600 is a current clamp that will allow your oscilloscope to measure electrical currents up to 600 Ampère AC/DC, with a frequency response up to 400 Hz. When measuring with this current clamp, there is no need to break a closed circuit or to affect the isolation.

The wide jaws allow performing measurements on thick conductors.

For measuring DC current, a simple to operate zero adjust button is available.

To connect the Current clamp TP-CC600 to your oscilloscope, a BNC to banana measure lead is required, which must be ordered separately. For oscilloscopes with differential inputs, the Measure lead TP-C812B is recommended. For oscilloscopes with single-ended inputs the Measure lead TP-BNCI-100 is recommended.

Order code: TP-CC600
EAN: 7423632935978
Price: 100.60

Category: Current Clamps

The table below shows detailed specifications of the Current clamp TP-CC600.

Electrical
Bandwidth	DC to 400 Hz (-3dB)
Effective measurement range
200 A range	output 1 mV/A, 1 V = 1000 A
600 A range	output 0.1 mV/A, 1 V = 10000 A
Accuracy
DC 200 A range	±(3% ± 0.6 A)
DC 600 A range	±(3.5% ± 3 A)
AC 200 A range	±(3.5% ± 0.4 A)
AC 600 A range	±(4% ± 4 A)
Output connection	2 shrouded 4 mm banana sockets

Dimensions
Captured conductor size	30 mm maximum
Weight	240 g
Height	30 mm (1.2 inch)
Length	209 mm (8.2 inch)
Width	43 mm (1.7 inch)

Power Requirements
Power indicator	Red LED
Battery type	Standard 9 V IEC 6F22 cell
Low battery indication	Red LED

Ambient
Operating Temperature	0 to 50 °C
Relative Humidity	25 to 70%
Storage Temperature	-20 to 60 °C
Relative Humidity	25 to 80%

Certifications and Compliances
CE mark compliance	Yes
RoHS	Yes